Here is the check management window:

• Create a new model,
• Edit a model.
• See the checks associated with a model.
• Delete a model.

Create a model

1. Click "Add a new model. The fields in the window are cleared.
2. Specify the different characteristics of the model:
   • Model name: This name will be used in the control description to select the desired planning options..
   • Delay between two controls: Time between two control executions. For example, if the interval is set to 2 hours, the check will be run every 2 hours.
   • Number of retries: number of times the check is retried before being considered in error.
   • Waiting time between two attempts: Tests are run at 2-minute intervals.. The time between two attempts must not exceed 2 minutes (120 seconds).
   • Time slots: Period of time during which the inspection is to be carried out.. To run the check throughout the day, the start time must be "00:00" and the end time "23:59".
   • Days of execution: Days of the week when the control is to be carried out.
3. Click "Validate". The check model is automatically created. It is added to the list of models and can be associated with a check.

Edit a model

1. Select the desired model from the list.
2. Edit the desired characteristics.
3. Click "Validate". The check model is automatically updated. Any checks associated with the model will also be updated.

See the checks associated with a model

1. Select the desired model from the list.
2. The characteristics of the model are displayed in the "Model parameters" section on the left of the window.
3. The checks associated with the model appear under "Tests associated with the model", on the right of the window.

Delete a model

1. Select the desired model from the list.
2. Click the button.