|
|
|
|
|
|
|
|
The following constants are used to manage diagrams: | | | | Constant | Details | Type of variable |
|---|
 New in version 28diagActionNone | Actions available on a shape: No actions available to the end user. | diagShape type | New in version 28diagActionAll | Actions available on a shape: All actions available to the end user. | diagShape type | | connectorSnapToAuto | How the connector will snap to the target shape: The connection point is automatically determined according to the position of the connector and the shape. | diagHead type | | connectorSnapToShape | How the connector will snap to the target shape: The end of the connector will snap to the center of the shape. | diagHead type | | connectorSnapToConnectionPoint | How the connector will snap to the target shape: The connector will snap to a connection point. | diagHead type | | connectorSnapToBoundingBox | How the connector will snap to the target shape: The end of the connector will snap to a point of the bounding box of the shape | diagHead type | | routeStraight | Type of route taken by the connector: The connector, which goes from the start point to the end point and passes through the waypoints, is a straight line. | diagConnector type | | routeOrthogonal | Type of route taken by the connector: The connector, which goes from the start point to the end point and passes through the waypoints, has right-angled bends. | diagConnector type |
This page is also available for…
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|