|
|
|
|
|
|
|
|
OriginWaypoint (Property) In french: OriginePointDePassage
 Warning
From version 27, OriginPassingPoint is kept for backward compatibility. This property is replaced by OriginWaypoint.
The OriginWaypoint property is used to get and define the origin of points whose coordinates are specified in the WayPoint property.
// The Wire control goes through the STC_Center control
WIRE_MyWire.OriginWaypoint = wireOriginWindow
pt1 is Point = [STC_Center.X, STC_Center.Y]
WIRE_MyWire.WayPoint = [pt1]
Syntax
Identifying the origin of points specified in the WayPoint property Hide the details
<Result> = <Wire control>.OriginWaypoint
<Result>: Integer constant Current origin taken into account for the coordinates of the points:
| | | wireOriginStartControl | The coordinates are relative to the top left point of start control for the Wire control. | | wireOriginStartPoint | The coordinates are relative to the start point of the Wire control. | | wireOriginWindow | The coordinates are relative to the origin of the window. Remark: This constant forces the Wire control to go through a fixed position even if the control is moved. |
<Wire control>: Control name Name of the Wire control to use.
Modifying the mandatory waypoints for a Wire control Hide the details
<Wire control>.WayPoint = <New Origin>
<Wire control>: Control name Name of the Wire control to be used <New Origin>: Integer constant New origin taken into account for the coordinates of the points:
| | | wireOriginStartControl | The coordinates are relative to the top left point of start control for the Wire control. | | wireOriginStartPoint | The coordinates are relative to the start point of the Wire control. | | wireOriginWindow | The coordinates are relative to the origin of the window. Remark: This constant forces the Wire control to go through a fixed position even if the control is moved. |
This page is also available for…
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|