|
|
|
|
DomoSwitchOff (Function) In french: DomoEteint Switches off one or more electrical devices compatible with the X10 protocol. These devices have been switched on by DomoSwitchOn or DomoSend. Remark: In order for the X10 protocol to operate properly through power-line carrier, continuous power is required between the devices. For example, the transmission cannot pass through an insulation transformer. // Open the X10 connection ConnectionID is int ConnectionID = DomoOpen("COM4", "A") Â // Switch on the lamps connected to the A3 and A4 modules DomoSwitchOn(ConnectionID, "A3 A4") // Equivalent to: DomoSend(ConnectionID, "A3 A4", domoOn) ... // Switch off the lamps DomoSwitchOff(ConnectionID, "A3 A4")
Syntax
<Result> = DomoSwitchOff(<Connection identifier> , <Address>)
<Result>: Boolean - True if the electrical devices have been switched off,
- False otherwise (transmission error, device did not respond, etc.). If an error occurs, use ErrorInfo with the errMessage constant to get more details on the error.
<Connection identifier>: Integer Identifier of the connection to use. This identifier is defined by DomoOpen. <Address>: Character string Address of the electrical devices (compatible with the X10 protocol) that must be switched off.The address format is as follows: <House code><Module code> Where: - <House code> corresponds to a letter found between A and P.
- <Module code> corresponds to a number found between 1 and 16.
For example: "A1", "B14". To specify several addresses, the addresses must be separated by a space character. For example: "A1 A3 B15".
This page is also available for…
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|