Horizontal coordinate of top left corner of the rectangle where the ellipse will be drawn (in millimeters).
Value included between 0 and the page width (returned by iPageWidth).

Vertical coordinate of top left corner of the rectangle where the ellipse will be drawn (in millimeters).
Value included between 0 and the page height (returned by iPageHeight).

Horizontal coordinate of bottom right corner of the rectangle where the ellipse will be drawn (in millimeters).
Value included between 0 and the page width (returned by iPageWidth).

Vertical coordinate of bottom right corner of the rectangle where the ellipse will be drawn (in millimeters).
Value included between 0 and the page height (returned by iPageHeight).

Thickness of the ellipse line (in picas). Default value = 1 (one Pica = 0.353 mm).
Caution: Depending on the value of this parameter, the thickness is achieved by adding several lines next to each others from the outside to the inside.

This parameter must correspond to an integer value. Otherwise, the thickness will be rounded to the nearest integer value.

Rate for the line color and for the background color. If this parameter is:

• Equal to 0 (default value): no fill.
• Equal to 100: entirely filled with the specified color.
• Less than 100: the closer this parameter is to 0, the more the color brightens.
• Greater than 100: the closer this parameter is to 200, the more the color darkens.

Color used for the background and for the border of the ellipse. If this parameter is not specified, the color used is black.
This color can correspond to:

• an RGB color (returned by RGB),
• an HSL color (returned by HSL),
• a preset color of WLanguage.

Type of line.

iContinuous (default value)	Solid line
iDotAndDash	Dot-and-dash line (-.-.)
iDotted	Dotted line (....)
iDashed	Dashed line (-----)

Pattern used to fill the border.

iCrossed	Crossed brush
iDiagonalCrossed	Brush crossed diagonally
iUpwardDiagonal	Upward diagonal brush
iDownwardDiagonal	Downward diagonal brush
iHorizontal	Horizontal brush
iSolid (default value)	Solid brush
iVertical	Vertical brush

This parameter is ignored.