ONLINE HELP WINDEV, WEBDEV AND WINDEV MOBILE
Version: 151617181920212223242526
Defining an attach point via its coordinates Hide the details
Identifier of the attach point. This identifier is used by ..AttachPointStart and ..AttachPointEnd.
Name of the start or end control of the Wire control.
Horizontal position of attach point in % (see the Notes). The value of this parameter must be included between 1 and 100.
Vertical position of attach point in % (see the Notes). The value of this parameter must be included between 1 and 100.
Defining an attach point via a Point variable Hide the details
Name of the Point variable corresponding to the attach point. The coordinates of the point are expressed in % (see the Notes).
Defining an attach point
Position of the attach point
Last update: 09/19/2020
Send a report | Local help
Searching...
I accept the terms of the license agreement
All you have to do is configure your product as follows: