ONLINE HELP WINDEV, WEBDEV AND WINDEV MOBILE
List of detected Wi-Fi access points separated by CR characters (Carriage Return),Empty string ("") if no Wi-Fi access point was detected. The ErrorOccurred variable is used to find out whether an error occurred while detecting the access points. ErrorInfo returns more details about the problem.For each network, a set of information is returned in the following format:
<Identifier> + TAB + <SSID> + TAB + <BSSID> + TAB + <Security> + TAB + <Signal strength>
where: <Identifier> : Identifier of the network associated with the access point, empty string ("") if the access point corresponds to no network configured on the device.<SSID>: SSID (Service Set Identifier) of the Wi-Fi network associated with the access point. <BSSID>: BSSID (Basic Service Set Identifier) of access point <Security>: Type of security used by the Wi-Fi network: wifiSecurityNoneNo security is used.wifiSecurityWEPSecurity based on a WEP key (Wired Equivalent Privacy)wifiSecurityWPASecurity that is using the WPA mechanism (Wi-Fi Protected Access).wifiSecurityWPA2Security that is using the WPA2 mechanism (Wi-Fi Protected Access).wifiSecurityWPA_EAPSecurity that is using the WPA mechanism (Wi-Fi Protected Access) and the EAP mechanism (Extensible Authentication Protocol).wifiSecurityIEEE8021XSecurity that is using the IEEE 802.1x standard.<Signal strength>: Signal strength expressed in dBm (decibel per milliwatt).
Maximum duration of detection in hundredths of a second. An error occurs if this timeout is reached before the end of detection. If this timeout is not specified or is set to 0, no time limit will be applied.This parameter can correspond to: an integer corresponding to the number of hundredths of a second,a Duration variable,Versions 23 and laterthe direct indication of duration (1 s or 10 ms for example). New in version 23the direct indication of duration (1 s or 10 ms for example). the direct indication of duration (1 s or 10 ms for example).
Last update: 08/26/2020
Send a report | Local help
I accept the terms of the license agreement
All you have to do is configure your product as follows: