PC SOFT

ONLINE HELP
FOR WINDEV, WEBDEV AND WINDEV MOBILE

  • Overview
  • Wizard for installing the monitor
  • Installing the monitor
  • Configuring the monitor of robots
WINDEV
WindowsLinuxUniversal Windows 10 AppJavaReports and QueriesUser code (UMC)
WEBDEV
WindowsLinuxPHPWEBDEV - Browser code
WINDEV Mobile
AndroidAndroid Widget iPhone/iPadApple WatchUniversal Windows 10 AppWindows Mobile
Others
Stored procedures
Installing the monitor
Overview
The monitoring robot includes three executables.
The first executable to install is the the executable corresponding to the robot. The monitoring robot is always started on a computer and it runs all the requested tests. It must be installed on a computer that will never be switched off.
The second executable is the robot controller (or counter-robot). Its setup is optional. The counter-robot is an additional security. It is used to check whether the monitoring robot operates properly. If it is installed, the counter-robot must be installed on a computer that will never be switched off, different from the setup computer of the monitoring robot.
The third executable is the monitor of robots. The monitor can be installed on any computer. It is used to edit the tests and the different parameters of the robot.
Wizard for installing the monitor

Installing the monitor

To install the monitor:
  1. Start the setup pack (WX220PACKROBOT.EXE) on the computer where the monitor must be installed. The setup wizard starts.
    Reminder: The setup pack (WX220PACKROBOT.EXE) is available in the "Install\Robot" sub-directory of the product used.
  2. Validate the license.
  3. Select "Install the monitor of robots" and go to the next step.
  4. Select the setup directory of the monitor of robots. Go to the next step.
  5. The setup is completed. Validate. The monitor of robots is installed. All you have to do now is configure the monitor of robots.

Configuring the monitor of robots

Once the monitor is installed, a wizard is automatically displayed to configure the monitor.
  1. Go to the next step.
  2. Specify the location of robot files. This directory corresponds to the shared directory created on the computer where the robot was installed. Go to the next step.
  3. Select the alert options of the monitor. These options correspond to the alert performed on the monitor if an error occurs. You can:
    • use a visual alert.
    • use a sound alert.
  4. Go to the next step. Validate. The setting of the monitor is performed.
You have the ability to create tests.
Minimum required version
  • Version 14
This page is also available for…
Comments
Click [Add] to post a comment